- Mass storage controller driver windows xp manuals#
- Mass storage controller driver windows xp install#
- Mass storage controller driver windows xp serial#
- Mass storage controller driver windows xp download#
Mass storage controller driver windows xp install#
This method obviously gets around the problem of XP not having the drivers on the install CD by you providing them manually.
Mass storage controller driver windows xp download#
If you’re unable to change RAID mode to IDE or disable SATA in the BIOS, then the next option would be to download SATA/RAID drivers from your motherboard manufacturer’s website, extract the drivers to a floppy disk and then insert the floppy into your computer during Windows XP installation. Integrated Peripherals > South OnChip PCI Device > SATA Controller > IDE Mode SATA Configuration > SATA Configuration > Configure SATA as > IDE Storage Configuration > SATA Mode Selection > Emulated PATA Mode
Mass storage controller driver windows xp serial#
Integrated Peripherals > Serial ATA Function > Base Integrated Peripherals > SATA Devices Configuration > SATA Mode >
Mass storage controller driver windows xp manuals#
Here’s some names we found it could be under in a few motherboard manuals we looked at: Don’t confuse this option with a similar one which will disable the SATA controller completely. Basically any option you come across to reduce the SATA/RAID mode to IDE/PATA should be the correct one. The most obvious thing to look for is a setting which can change the SATA controller to IDE or PATA mode, with options such as AHCI -> IDE or SATA/RAID -> IDE etc. If you have a manual, it’s certainly worth reading. It depends entirely on the computer or motherboard’s make, model and manufacturer to know which setting you have and where it is. The problem with this setting is it comes under several different names and can be found in different sections within the BIOS. Most BIOS’s for several years have included a fallback mode to enable a SATA drive to behave like an IDE drive, and therefore makes it visible to XP during setup. The first and mos obvious method is to change the SATA Mode to IDE in the system BIOS. Thankfully there are a few ways to get around this problem and enable Windows XP to be installed onto a SATA hard drive so you can enjoy the extra performance and other functions like hotplug/AHCI etc. As most computers within the last decade or so have some form of SATA controller, if you try to install Windows onto a SATA drive, XP won’t recognize it because the drivers aren’t present on the installation disc, so they need to be loaded manually for the drive to be picked up. This problem is quite a common one and is simply due to the fact that when Windows XP was created, the SATA chipset itself and SATA hard drives weren’t available to the masses, so support for it wasn’t included in the XP setup process. This may involve running a manufacturer-supplied diagnostic or setup program. Make sure any hard disk drives are powered on and properly connected to your computer, and that any disk-related hardware configuration is correct. Setup did not find any hard disk drives installed in your computer. The hard drive is detected with no problem in the BIOS and also on start up POST, able to boot up Linux Live CDs but the hard drive is just not being detected in Windows setup. When users try to install Windows XP, they encounter the problem of not being able to find any hard disk drives installed as if they weren’t connected. We’ve seen this question posted in our forum many times, so thought we should write an article on this problem.
0 kommentar(er)
